Des exemples practiques de l’ utilisation industrielle
A-LAS-F08-...
1) Sélectionnez une langue:
|
Defect recognition on saw blade discs Defects on saw blade discs should be detected. |
|
||||||
|
Pin width control of electrical components The width of the pins of an electrical component should be controlled. |
|
||||||
|
Spray jet amount control The density of the spray jet should be controlled. |
|
||||||
|
Spiral position control on a filament The position of the spiral coil on a filament for the light bulb industry must be controlled. There are two different types of spirals, different in gapping, on the filament. The speed of the filament is approximately 0.02m/s, the diameter of the filament is dependent of the type (min. 0.3mm and max. 1.5mm) and the maximum gapping of the spiral is 1mm. |
|
)
TOP