N° 344
|
Double sheet control of veneers
During the transportation of veneers, it should be controlled whether one or more than one veneer was picked up from a handling system.
|
|
N° 127
|
Mätning av håldiameter Diametern på hål i ett aluminiumblock ska mätas. Hålen kan ha diametrar upp till 8mm.
Diameter control of holes
The diameter of holes in an aluminum bloc should be controlled. Holes with diameters up to 8mm must be measured.
|
|
N° 70
|
Detektion av positioneringsmärke på metallplatta Ett ingraverat märke på metallplatta ska detekteras för att positionera plattan korrekt.
Detection of an engraving mark on a metal plate
An engraving mark which is used for positioning in x-, y- and roll-direction has to be detected.
|
|